GasAlertMicroClip
Options
Sensor Disabled
Detector Identification
a
Warning
Start-up Message
Disabling an installed sensor configures the
detector to a 1, 2, or 3-gas unit. No protection is
now provided for the gas targeted by that
sensor(s). Disabling a sensor should be
performed with extreme caution.
This option allows you to personalize your detector. In the
Detector Identification group there are two fields available for
you to enter a message:
Startup Message Top Line
; and
Use the
Disabled
function to disable a sensor. If a sensor is
disabled, it can no longer be viewed on the LCD during
normal operation. All sensors are enabled upon shipment. If
a sensor is disabled, it may be enabled again at any time
Startup Message Bottom Line
.
If a message is entered, it appears during the start-up
sequence after the detector version is displayed. The
message either
If a sensor fails, disabling the sensor deactivates the sensor
alarm (refer to
Alarms
). The sensor should be replaced and
enabled as soon as possible (see
Replacing a Sensor or
Sensor Filter
).
a)
displays on the LCD for 3 seconds (if the entire
message fits on the LCD); or
b)
scrolls by twice on the LCD.
The detector functions normally with the remaining enabled
sensors.
Sensor Options
The sensor options tab allows you to change the factory
settings for the H
2
S, CO, O
2
, and LEL sensors.
17
