Safety instructions
14
V-LOAD Cutter Megastar silage block cutter
2.3.2
Responsibilities of the operator
Before commencing work, all personnel designated to work with / on
the accessory equipment are required to:
observe all national, generally applicable regulations regarding
safety and accident prevention as well as environmental
protection,
read and observe chapter "Safety instructions", starting on
page 10 of this operating manual,
read chapter "Warnings and instructions", starting on page 28 of
this operating manual and observe it while operating the
accessory equipment,
become familiar with the accessory equipment,
read the chapters in this operating manual that are essential for
the execution of the work tasks they have been assigned.
If detecting that a fixture is no longer fully compliant with the safety
regulations, the operator is required to remedy this defect immediately.
If the correction of a fault is not part of the operator's responsibilities or
the operator lacks the necessary expertise, the operator must report
the defect to his supervisor or the owner.
2.3.3
Qualification of the personnel
Work with / on the accessory equipment is limited to qualified and
trained personnel. The operator must clearly define the
responsibilities of the personnel with regard to operation, maintenance
and repairs.
A person in training may only work with / on the accessory equipment
when supervised by an experienced member of the personnel.
The operator may only perform the work described in this operating
manual.
Work on the accessory equipment that requires professional expertise
may only be performed by specialty workshops. Specialty workshops
have the qualified personnel and suitable means (tools, lifting and
supporting devices) that are necessary to perform the work in a
professional and safe manner.
This applies to work:
not described in this operating manual,
that is identified as "work to be performed at a workshop" in this
operating manual.