Maintenance and inspection
Butzbach GmbH Industrietore
Originalbedienungsanleitung SPACELITE_V1
24/02/2021
34
9.2.2 Reasons for extraordinary inspection
The operational readiness of the system should be checked outside of the prescribed maintenance cycles at
shorter intervals if it is determined that:
the door system is extraordinarily dirty or was not sufficiently maintained,
the door construction shows damage, e.g. damaged door elements or guide rails,
the usual functionality is disrupted, e.g. from diagonal door elements on the consoles or in the
guide rails
the maintenance intervals are exceeded,
the expected useful life has been reached (age of the door system, number of times door opened).
an unusually large quantity of dust has entered into the door's mechanical parts,
the door system is exposed to corrosive gases or liquids, e.g. in areas of sewage treatment plants or
chemical production facilities,
the tracks of the door parts or the fall arrestors have scratches or rough areas,
the tracks are misshapen,
metallic abrasion is visible at the base of the guiderails (also see the operating manual for the anti-
drop device),
unusual operating noises can be heard in the system, e.g. metallic banging, scratching or grinding
noises.
9.2.3 Testing by a qualified individual
Have the following components tested by a qualified individual?
Functioning of consumable parts (authorised qualified personnel have additional information in the
service and maintenance manual).
Function of mechanical protective devices, e.g. proper assembly of the cover plates.
Function of support bolts, chain guides, etc.
If present: Function of additional control unit component (e.g. other photo eyes, contact loops, etc.)
Checking connections to the building in accordance with DGUV 208-022 appendix 3
Check whether the required warning signs are attached to the door system.
Additionally, for HT150XL: Check the hydraulic components for seal and function
Keep evidence of these tests in the form of a test book.
9.2.4 Inspection and maintenance plan for consumable parts for SPACELITE
®
doors
For the following listed components, to the extent that nothing is otherwise noted in the table below, a useful
life specific to the door applies, which corresponds to ten years in a normal industrial environment (C3 - EN
ISO 12944) and normal climate (23°C, 50H).
HT40:
80.000
HT60:
50.000
HT60XL, HT80, HT150, HT150XL:
30.000
