INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 42 of 111
GB
AIKIDO.34LIGHT-AIKIDO.34LIGHTFI
7101-M001-0_B
Fig. 49
Fig. 50
THE MANUFACTURER DOES NOT
ACCEPT ANY DAMAGE RESULT-
ING FROM THE FRAILURE TO
OBSERVE THE ABOVE INSTRUC-
TION, AND SUCH FAILURE
COULD INVALIDATE THE WAR-
RANTY!!
• At regular intervals, at least every two months, verify
the rubber protections conditions, in relation to point
3.0 Safety devices. If necessary replace damaged parts
requesting for them to the supplier.
• Every
week
and/or when necessary, top up the oil tank
using the filler hole provided closed by a cap or screw
on the lubricator filter.
N.B: This operation should not be carried out by
unscrewing the cup of the lubricator filter.
• The use of synthetic oil might damage the pressure
regulator filter.
• At regular intervals, (at least every 100 working hours)
check reduction gear (
Fig. 49 pos. 1
) lubricating oil
level. Such operation must be effectuated removing the
plug (
Fig. 49 pos. 3
), positioned on the provided hole
prearranged on the frame, and removing the plug po-
sitioned on reduction gear (
Fig. 49 pos. 2
).
13.1 Replacement of the feeler pin
After a certain number of operations it’s possible that
the (upper and/or lower) feeler pin can deform so that it
can’t ensure a proper functioning; in this case its re-
placement can be carried out following these simple op-
erations (
Fig. 50
):
• Unscrew the deformed feeler pin
• Replace it by a new feeler pin, keeping the head of the
screw pressed in order to facilitate this operation.
THE FEELER PINS MUST BE
ABSOLUTELY ORIGINAL; DON’T
REPLACE THEM WITH IMPRO-
VISED FEELER PINS, DON’T
MODIFY THE ORIGINAL FEELER
PINS.
