INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 31 of 111
GB
AIKIDO.34LIGHT-AIKIDO.34LIGHTFI
7101-M001-0_B
9.3
Electrical connection
EVEN THE TINIEST PROCEDURE
OF AN ELECTRICAL NATURE
MUST BE CARRIED OUT BY PRO-
FESSIONALLY QUALIFIED
STAFF.
As envisaged by the regulations in force, the machine is
not equipped with a master circuit breaker, but simply
has a plug-socket connection to the electrical mains.
The machine is supplied with
3
mt. of free cable. A plug
corresponding to the following requirements must be
connected to the cable:
• Conformity to Norm
IEC 309
•
230/400 Volt – 16A
•
2P + Ground
•
IP 44
VERSION WITH
MONOPHASE MOTOR
On delivery, the machine is preset to operate at a voltage
of 200 ÷ 265 V - 50/60 Hz monophase.
9.4
Working area modification
After the delivery, the machine is prearranged to operate
on wheel of 50” maximum diameter and a rim diameter
(10” - 30”). It’s possible to move the tools column to
enlarge the working area from 52” (with rim diameter of
12” - 32”) to 54” (with rim diameter of 14” - 34”) (see
Figure 10
).
Fig. 10
The column handling is possible unscrewing the fixing
screws of the base (
Fig. 10 pos. A
) to the column (
Fig.
10 pos. B
) and sliding the base (
Fig. 10 pos. A
) into the
proper slots until the required measure.
MAKE SURE THAT THE TYRE
CHANGING MACHINE COLUMN IS
STABLE USING A CABLE WITH A
BLOCK TO LOCK ON THE LIFTING
CROSS BEAM (FIG. 11 POS. 7).
1. To remove the lateral guard (
Fig. 11 pos. 1-2
) of the
machine.
2. To unscrew the screws (
Fig. 11 pos. 3
) and the nuts
near the central slots (
Fig. 11 pos. 4
) playing atten-
tion to not remove the nuts from the proper screws.
3. To remove six remained screws (
Fig. 11 pos. 5
).
4. To move the base (
Fig. 11 pos. 6
) into the required
position (to 52” or 54”) and if necessary to use a lift-
ing device (
Fig. 11 pos. 7
).
5. To lock the base three screws (
Fig. 11 pos. 3
) with a
couple of 80 Nm.
6. To place six screws (
Fig. 11 pos. 5
) previously re-
moved and to lock them on the base side with a cou-
ple of 80 Nm.
