burmeier Dali, Instruction Manual

Page: 61 / 132

4.2 Pairing the Bluetooth Handset
4.3 Making Ready for Operation
First remove the magnets from the handset to avoid any malfunction.
In the Dali standard, wash and low-entry.
Before the bed functions can be adjusted, the handset must be coupled (connected) with the
control unit.
Proceed as follows:
1. Plug the power pack into the electric socket.
• If the power pack was already in the socket, remove the power pack from the
socket, wait approx. 10 s and plug it in again.
2. Within 20 s, press the two buttons for up/down mattress base height simultaneously for
at least 5 seconds.
Then wait 20 s.
The LED on the control unit lights up orange for 4 seconds if coupling was successful.
The LED on the control unit flashes orange 4 times if the coupling was not successful. In
this case, repeat steps 1 and 2.
For information on how to operate the handset and change its battery, see Part C: Hand-
set
»
9
Allow the bed to adjust to room temperature for about 20 minutes if it was stored beforehand
at the lowest or highest permissible temperature.
After the bed has been assembled, carry out a check in accordance with the chapter Part B:
Maintenance
»
31 .
Clean and disinfect the bed before it is used for the first time and before every re-use in ac-
cordance with the chapter
Part B: Cleaning and Disinfection
»
26 .
The bed is ready for operation if all the steps described in the chapter Assembling the Care
Bed have been read and carried out successfully.
Putting into Service
Part B: Operator and Technical Personnel 25