Bürkert 8035, Instruction Manual

Page: 52 / 112

E-14-
FLOW TRANSMITTER 8035
Supply
12..30Vdc
FLOW SENSOR
COIL NPN
L+ L- PE P- P+
NC
L+
L-
PE P- P+
Iout
PULSE
OUTPUT
Without
With
Relays
3 INSTALLATION
3.3.4 Using switch FLOW SENSOR
Before wiring the device, make sure that the switch of the electronic board is correctly
positioned.
Output signal of Switch
Transmitter the flow sensor "FLOW SENSOR"
8035
Pulse NPN NPN
Sinus (coil) COIL
3.3.5 Electrical wiring of transmitter 8035, 12-30 VDC, without relay, with
cable glands
Before wiring the device, please read § 3.3.1, 3.3.3 and 3.3.4 carefully.
Lift the transparent lid after having unfastened the screw. Remove the cover of the device
by unscrewing the 4 screws, pass the cables through the cable glands and connect
according to the pin assignment below.
Always seal the unused cable gland using the supplied obstructor to
ensure the tightness of the device.
Unscrew the cable gland nut, insert the obstructor and screw the nut
back onto the cable gland.
Only manipulate the switches when the device is not powered.
L+ (12-30 VDC)
L- (0V)
Connect the shielding of the power supply cable
Flow sensor connection
Pulse output
팫
Not connected
Switch "Sensor Type" :
see § 3.3.4
Pulse output
팬
Earth (internally connected to
the earth plug)
Wiring of the SE35, 12-30 VDC, without relay, with cable glands
Fig. 3.6
FLOW SENSOR
COIL NPN