HDBaseT™ 4K Transmitter with HDMI / VGA Auto-Switch
TX-SW-0201
Quickstart Guide
In the Box
1 x TX-SW-0201 Transmitter
1 x 12V DC 1A Power Supply
1 x 3-pin Screw Down Phoenix Connector
Front Panel
VGA Input
15-pin VGA VESA (D-SUB 15): Connect to D-SUB
15 VGA output of device such as a computer.
HDMI Input
19-pin type A HDMI female digital video/audio input:
Supports HDMI and DVI/D (requires adapter-not
included) Limited to 275 MHz pixel clock.
Audio In
3.5 mm (1/8 in) Stereo Analog Audio: Connect to
audio output of device connected to VGA input.
Rear Panel
Update
3-pin Screw Down Phoenix Connector: Used for
updating transmitter firmware
Status LED
Solid - Link to receiver has been established.
Flashing - Link to receiver has not been established.
UTP Out
8-pin RJ-45 female: Connect to an HDBaseT
receiver. See
for wiring details.
12V DC In
12V DC 1A: Connect to supplied power supply.
Power LED
Illuminates when DC power is applied.
A
A
B
B
D
C
C
E
A
B
C
A
B
C
D
E
TX-SW-0201 Front
TX-SW-0201 Rear
Basic Wiring Diagram & Installation
IMPORTANT!
Do not connect or disconnect (hot plug) the VGA,
HDMI, or HDBaseT connections while the transmitter is powered
on. Doing so may cause damage to the transmitter or connected
devices.
1. Install the TX-SW-0201 in on a solid flat surface such as a cabinet or
rack shelf located in a dry, well ventilated area.
Tip: WyreStorm recommends using the mounting brackets (not
included) whenever possible to avoid the transmitter from moving
due to cabinet vibrations.
2. Connect an HDMI source to the HDMI In on the transmitter using an
HDMI cable from a high quality brand such as
.
3. Connect a VGA source to the VGA In on the transmitter.
4. Terminate a cable per the
section and connect to
the UTP Out on the transmitter.
5. Connect the opposite end of the HDBaseT cable to a
, switcher, or 3rd party display device with built-in
HDBaseT receiver.
6. Connect the power supply to the 12V DC input on the transmitter.
HD TV / Projector with built-in receiver
or HDBaseT Receiver (not shown)
KEY
HDMI
HDBaseT Cat5e/6
VGA Video
Analog Audio
Power
Auto-switching HDBaseT™ transmitter for sending a VGA or HDMI signal to a device with integrated HDBaseT receiving capability such as a display or
projector 100m/328 ft (4K - 70m/230ft) away. Perfect for small meeting room or classroom environments.
VGA Video
12V DC 1A
HDMI
Video / Audio
Mains
Power
HDMI Source
VGA Source
HDBaseT
Cat5e/6
Analog Audio
Copyright © 2015 WyreStorm Technologies |
TX-SW-0201 Quickstart Guide | 150908
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
1 of 2
