Burkert 8640, Operating Instructions Manual

Page: 69 / 196

8640 - 67
F
IELD BUS
M
ODULE
PROFIBUS DP / V1
Parametritation without extension islands (hex parameter
1
/ User_Prm_Data
2
)
The default settings parametrization are:
Extension island none
Input mode normal inputs
Filter on
By parametrization, the settings chosen for the input mode and the filter
can
be changed.
Input mode Input filter off Input filter on
no inputs 04 hex 44 hex
normal inputs 14 hex 54 hex (default)
staggered inputs 24 hex 64 hex
halved inputs 34 hex 74 hex
For a description of the input modes and the output filter, see Section „input mode“
Byte 11 User_Prm_Data (user parameters)
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte Busparameters ( standardlparameter ) 7 Bytes
1 Lock_Rep Unlock_Re Sync_Req Freeze_Req WD_On reserved reserved reserved
00 min TSDR and slave specific data Slave is
operated in
sync mode Slave is
orperated in
freeze mode Reponse
monitoring
0: deactivated
1: activated
01 release for other masters
10 block for other masters
11 release for other masters
2 WD_Fact_1 (Range 1 - 255 Reponse monitoring in [s] = 10ms * WD_Fact_1 * WD_Fact_2)
3 WD_Fact_2 (Range 1 - 255 Reponse monitoring in [s] = 10ms * WD_Fact_1 * WD_Fact_2)
4 TSDR
(Time in Tbit, when the slave may reply. At least 11 Tbit, 0 old value remains)
5 Ident_Number high Byte (Marker´s identifier 00 Hex)
6 Ident_Number low Byte
(Marker´s identifier 81 Hex)
7 Group_Ident (for group formation, each bit represents a group)
User_Prm_Data (DPV1_Status)
8 DPV1_Status_1
9 DPV1_Status_2
10 DPV1_Status_3
User_Prm_Data (user parameters)
11
NOTE
In many configuration tools, there is no direct access to bytes 1 to 7. With Siemens
(Steps 5 and 7), the parameters begin with byte 8.