Burkert 8285, Instruction Manual

Page: 59 / 288

59
Inserting the SmartMedia card
Please note when inserting the SmartMedia card:
Protect against electrostatic discharge!
The analyzer must be opened to insert or replace the SmartMedia card.
Power can remain on. When closing the device, make sure that the sealing is
properly seated and clean.
Inserting the SmartMedia card
Warning!
Do not touch the terminal compartment, there may be
dangerous contact voltages!
1. Open the analyzer
Loosen the 4 front screws
Open the FRONT module at its right side
(pivot hinge inside at the left)
The slit for inserting the SmartMedia card is
located at the inner side of the FRONT module
2. Insert SmartMedia card
Remove SmartMedia card from its package
without touching the contact surface
Insert card in the slit at the inner side of the
FRONT module
•
•
•
•
•
Inserting the
SmartMedia card:
The label must be facing
you.
3. Remove SmartMedia card
To avoid data loss, please call up the Maintenance
menu.
Select “Close memory card” to terminate software
access to the SmartMedia card. Now the card can
be taken out. •
•