Burford 2200M, Manual

Page: 121 / 214

Troubleshooting 117
Error Code: E114
Controller is not able to move the needle to its
starting position.
This error only occurs while the tyer is in its homing sequence. After all motors have
found their home proxes, the controller tries to move all motors to their starting
positions. If the needle motor has not reached its starting position after trying for 30
seconds, then this error is set.
SAFETY WARNING
The following troubleshooting procedure may require that tests be made with the
electrical enclosures open and power turned ON. These tests should only be
conducted by authorized personnel who are aware of the electrical and
mechanical hazards present.
The most likely reason for this error
is a mechanical interference or jam
which is preventing the needle from
moving as needed. Check for this
type of problem.
Clear jam
Check for low voltage
at the motor power
supply. If problem
persists, replace the
AMP board.
Flow Chart 0-11 Error Code: E114