Burford 2200M, Manual

Page: 101 / 214

Communications 97
+ command
This command provides a "back door" way of getting access to the tyer's controller if the
tyer will not successfully home or if you wish not to home the tyer. This command causes
the tyer to bypass the homing sequence that normally must successfully complete before
you can type commands. In particular, this command permits you to perform inquiries
(Such as the QUERY command) and to view the contents of the Trouble buffer described
earlier in this document.
To invoke this command, hold down the shift key and press the key with the + character.
It is not necessary to press Enter. When the Motor 1> prompt appears, you will be able
to enter other commands.
Never attempt to run the tyer servomotors while the tyer is in this mode.
After completing your inquiries, you should always turn off power to
the main electrical enclosure for a few seconds before continuing. This
will reset the processor and assure safe operation.