Burford 2200M, Manual

Page: 108 / 214

104 Chapter 7
Seven Segment LED Error Codes
Mounted on the operator panel is the seven segment LED which can display all of the
numbers and most of the alphabet, one character at a time. This device is used to display
various codes that give the Tyer's status and may be helpful in troubleshooting. The codes
are divided into three categories: counter, status and error. The CPU keeps a running
count of the number of packages tied by the Tyer. During normal operation, the letter 'C'
will be displayed followed by this count. Status codes begin with the letter 'H'. These
codes give general information pertaining to the current Tyer status. Error codes begin
with the letter 'E'. These codes will give information pertaining to a Tyer fault. For more
information on how to use, the error codes to troubleshoot the Tyer
Once an Error Code has been displayed, it will be repeated until a new code replaces it
or power is turned off. Generally, you will have to home the Tyer or tie a package before
the code will be removed. The following is a list of the codes and their description.
CODE DESCRIPTION
H001 Main electric box power switched on
H002 External reset detected
H003 Tyer HOMING sequence aborted by operator
H004 Tyer not ready, close door and push START
H005 Ribbon drop detected. Thread tyer.
H006 Two bags were too close together
H007 Tie cycle aborted, not enough ribbon used
H008 Heel detected, too much ribbon used
H011 Needle at end of forward travel
H012 Needle at end of backward travel
H021 Twister hook at end of forward travel
H022 Twister hook at end of backward travel
H031 Holder/shear at end of forward travel
H032 Holder/shear at end of backward travel
H051 Motor control loop ran out of time.
H052 Command table out of order.
H159 Loss of clock: push RUN
H160 Reset instruction: push RUN
H162 Test module reset: push RUN
E001 Tie cycle aborted: ribbon not threaded
E101 CPU detected a problem and stopped tyer
E102 HOMING sequence failed
E111 Unable to control needle while homing