Burford 2200M, Manual

Page: 49 / 214

Installation 47
Bagger-active circuit
This signal from the bagger to the tyer indicates the status of the bagger and it must be
a 110 VAC, 220 VAC or 24VAC This signal can be taken from across the coil of the
clutch relay of most baggers. This signal drives the coil of a mechanical relay (CR1),
which starts and stops the brush motor and gathering belts of the Tyer. This connection
is used to prevent the Tyer's gathering belts and brushes from running while the bagger
is stopped. This will prevent a package from being pulled forward over a conveyor flight.
This will also reduce wear on the brushes and conserve energy during long breaks or
periods of maintenance in other areas. This connection can be made using wires 40 and
43 in the flexible conduit coming from the main enclosure. Wire 40 should be connected
to the Line side of the coil and wire 43 should be connected to the Neutral side of the
coil. For setup and testing, the gathering belts and brushes can be made to run while the
bagger is inactive by placing the switch on the front of the operator panel marked
BELT/BRUSHES in the ON position.
Installation Arrangements
A Burford
®
factory trained Technician may be hired for any installation. The arrangement
can be made with the Service Manager Service@Burford.com or:
Burford
®
Corp.
Maysville, Oklahoma
Phone: 1-877-BURFORD
®
or 405-867-4467
Fax: 405-867-4219
Note: Wires 40 & 43 should be wired into the
bagger so anytime the bagger is “CYCLING”, 110
VAC is supplied to these wires.