Page 24
Check valve replacement: All models
1. Connect brewer to power source. Use the “TEST
OUTPUTS/TEST INDEX MOTOR” to move it to
“DUMP POSITION”.
2. Unplug brewer.
3. Remove sprayhead/seal assembly:
AutoPod: Unscrew sprayhead/seal assembly.
My Café AP: Remove top cover. Remove thumb-
screw. FIG 24-1. Open door and remove sprayhead/
seal assembly (You may need to push sprayhead/
seal assembly down with a screwdriver). FIG 24-2.
4. Remove check valve with a spring hook or dental
pick. FIG 24-3.
EJECTOR ASSEMBLY
FIG 22-3 Exploded view.
41169 120711
FIG 24-1 Remove thumbscrew
DO NOT LOSE WASHER!
FIG 24-2 Remove sprayhead/seal assembly
5. If check valve pulls apart, remove remaining
piece with a spring hook or dental pick.
6. Install new check valve with O-ring end in first.
WARNING: NEVER RE-USE CHECK VALVE AF-
TER IT HAS BEEN PULLED OUT.
7. Remove seal from sprayhead.
8. Check and clean the sprayhead. The sprayhead
holes must always remain open. Clean all the holes
in the plastic sprayhead to remove any mineral
deposits. Wash and rinse in sink.
9. When reassembling sprayhead, be sure to have
seal installed with ridge facing up. Fig 24-4.
10. Install sprayhead/seal assembly (and thumbscrew
and washer if equipped). Install top cover and
screws.
11. Power up brewer and Press “OPEN/CLOSE” button
to reset pod holder to home position.
FIG 24-3
Water check valve
Air check valve
Shown outside brewer for clarity
FIG 24-4
Rib facing up
