Page 10
COMPONENT ACCESS
This section provides procedures for testing and
replacing various major components used in this
brewer should service become necessary. Refer to
Troubleshooting for assistance in determining the
cause of any problem.
WARNING - Inspection, testing, and repair of electri-
cal equipment should be performed only by qualified
service personnel. The brewer should be unplugged
when servicing, except when electrical tests are re-
quired and the test procedure specifically states to
plug in the brewer.
WARNING -
Disconnect the brewer from the power
source before the removal of any panel or the replace-
ment of any component.
All components are accessible by the removal of
the top cover or back cover.
Refer to wiring diagrams at the back of this
manual when reconnecting wires.
Contents
Access ...................................................... 10
Control Board .......................................... 11
Inlet Valve ................................................. 12
Tanks ........................................................ 13
Temperature Probe .................................. 14
Vent Valve ................................................. 15
Air Pumps ................................................. 16
Water Pumps ............................................ 17
Flow Meter ................................................ 18
Ejector Assembly .................................... 19
Schematics ............................................... 25
FIG. 10-1 COMPONENT ACCESS
41169 120711
