Bull NovaScale R630 E1, Setup Manual, Page: 89 / 146

4-39
IMPORTANT:
„
To perform this procedure, you need to log on as an administrator or a
member of administrator group.
„
RDR can only be set on the basic disk inserted into the built-in slot of
Fault Tolerant Server series. It cannot be set on the dynamic disk.
„
For the disk on which RDR is set, use the products with the same serial
number.
„
Be sure to configure the RDR settings in the same way not only when
the OS is installed but also when the disk is added to the PCI module.
„
Create partitions only after the duplication of the hard disk drives are
configured.
Follow the steps below to configure the dual disk configuration.
IMPORTANT:
The following describes the dual disk configuration of the slot 1.
If the HDD is mounted to the slot 2 or the slot 3, follow the procedure below to
configure the dual disk configuration likewise.
1.
Insert a new HDD into an internal HDD slot.
IMPORTANT:
If the HDD is already mounted, this procejure is not required. Proceed to Step 2.
2.
Start [Management Tool] by going
to [Start] – [Control Panel], and
select [Disk management on the
left tree. If the disk you want to
duplex is shown as “Not
Initilized,” right click on the disk
to initialize.
TIPS:
A popup window is displayed
when you inserted or
initialized the disk; however,
you do not need to restart the
system. Select [No] to exit the
popup window.