Bull NovaScale R630 E1, Setup Manual, Page: 34 / 146

3-6
z
Required tool
To install the device to the rack, a Phillips-head screw drive is required.
●
Checking the place to install
Decide the place (height) to install. To keep
balance, install it as low as you can on the rack.
To install the rack, the height for 4U is required.
IMPORTANT:
To install this device to the rack, the space for 1U is required for installing the USB
compatible floppy disk drive, in addition to the space for 4U.
Next to the square hole of the rack, an imprinted mark is placed for 1U (This is the unit to show the
height of the rack). This device is as high as 4U (about 176 mm), so install it between the imprinted
marks that indicate the height of 4U.
Imprinted mark
Places to install
core nuts
Imprinted mark (2
imprinted marks for
5Us)
4U (the height
for installing this
device)