30
Installation and starting up
The original package is designed for dispatch by post. Keep it in case you need to return the blender to the
supplier. Before installing the blender strictly follow all points of the safety instructions specified before.
After removing the blender from its package, check that it is in perfect condition and check that no type
of material, packaging, warranty sheet or anything else has accidentally entered inside the housing of the
motor base (6) (e.g. around the top gear 20) or in the jar (3) during transport or unpacking.
Keep the plastic bag containing the blender away from children: it may cause suffocation.
Do not plug in the blender until it has been correctly and completely assembled and always unplug the
blender after use.
Before using for the first time, wash the filler cup (1), the lid (2), and the jar (3).
For a quick wash, pour a glass of hot water into the jar and add a drop of detergent.
Place the lid (2) and the measuring filler cup (1) on the jar and use the selector (11) to run the blender for
at least 30 seconds. Pour the water from the jar and rinse it thoroughly before using it again.
Wash with neutral, non-abrasive and non-corrosive detergents, rinse and dry carefully.
To remove the dust that may have accumulated on the motor base body (6) of the blender, simply wipe
with a dry soft cloth.
1) Insert the lid (2) assembled with the filler cup (1) on the top of the assembled jar (3); to do this please be
careful to put the stepped part of the lid in correspondence with the pouring part of the jar.
2) The blender is provided with the Bugatti Safety system, that prevents the motor from being activated unless
the lid is perfectly put on the jar and the jar itself is correctly put on the motor base (6).
3) After making the above checks, and complying strictly with the safety instructions, connect to the main
power supply.
Connecting to the power supply: electric current can kill. Comply strictly with the safety instructions.
The Vento blender must be connected via the power cable (7) to a socket which voltage complies with the one
indicated on the rating plate under the blender.
Before unplugging the blender, make sure that it has come to a complete standstill. Check that the speed
selector (11) is set at zero (0), wait for the current task to finish and then remove the plug from the wall socket.
Never remove the plug from the socket by pulling on the cable (7).
Never use defective or damaged cables.
Never allow parts carrying live voltage to come into contact with water: you may cause a short circuit!!!
(adhere strictly to all points of the safety instructions specified before).
