Chapter 7 | Repair
www.buffalofilter.com +1 716.835.7000 (International) 800.343.2324 (United States) [email protected]
Disassembly
(continued)
7-9
Motor Boot Assembly for Model VV120 and VV220
1. Remove the Fascia Assembly by following the Fascia
Disassembly instructions on page 7-4.
2. Remove the HOUSING TOP VV by following the Body
Disassembly instructions on page 7-6.
3. Disconnect the two (2) gray motor wires from the printed
circuit board connectors J1E (FAN-LN) and J1D (FAN-NU)
(
Figure 7-16
).
4. Disconnect the green/yellow wires from the ground lug
using a 7/16 in. nut driver (
Figure 7-16
).
5. Locate the four (4) nuts and washers that secure the filter
basket to the housing bottom assembly and remove using a
5/16 in. nut driver (
Figure 7-17
).
6. Remove the filter basket and the boot assembly by lifting
both the boot and the filter basket out of the housing bottom
assembly (
Figure 7-18
).
Motor Wires
Ground Lug
NUT 6-32 W/WASHER SS
Qty - (4)
Filter Basket
HOUSING BOTTOM VV
Boot
Assembly
Filter Basket
Figure 7-16
Figure 7-17
Figure 7-18
