Chapter 7 | Repair
7-13
www.buffalofilter.com +1 716.835.7000 (International) 800.343.2324 (United States) [email protected]
Reassembly
(continued)
Motor Boot Assembly for Model DKVV220
1. Place the filter basket and the boot assembly into the
housing bottom assembly (
Figure 7-27
).
2. Slide the filter basket to seat it fully into the boot and that
the filter basket holes line up with the PEMS in the housing
bottom assembly (
Figure 7-27
).
3. Secure the filter basket to the housing bottom assembly
with the four (4) nuts and washers using a 5/16 in. nut
driver (
Figure 7-28
).
4. Secure the green/yellow wires to the ground lug using a
7/16 in. nut driver (
Figure 7-29
).
5. Connect the two (2) gray motor wires to the printed circuit
board connectors J1E (FAN-LN) and J1D (FAN-NU) (
Figure
7-29
).
NUT 6-32 W/WASHER SS
Qty - (4)
FILTER BASKET
NOTE:
Make sure none of the wires get trapped under the
boot assembly.
NOTE:
When tightening screws, do not exceed 10 inch-
pounds of torque to reduce the risk of damage to the filter
basket.
NOTE:
Push in all the wires between the boot and the
housing bottom assembly.
HOUSING BOTTOM VV SEALED
BOOT
Assembly
Filter Basket
Motor Wires
Ground Lug
Figure 7-27
Figure 7-28
Figure 7-29
