BTI 4.3 TFT, Installation Manual

Page: 7 / 60

7
As per the AEM Infinity 6 and 8h documentation:
The plug and pin harness has two signal wires (Green and White). Pin the White wire to
CAN A High and the Green wire to CAN A Low on the corresponding connector. Connect
the Red wire to a switched on / ignition power source and connect the Black wire to ground.
2 Pin Analog Out Connector (Brown and Blue Wires)
The termination of these two wires is dependent on the inputs that are assigned in the Infinity
Tuner software. These inputs are assigned in the software under
Wizards > Advanced
Setup
> “ModeSwitch Input Setup” or “Traction Control Slip Target Trim Input Setup”. The Input
used will be defined here. Connect the blue and brown wires to the corresponding inputs that are selected
for your application. There are more details regarding this under “BOOST and PWM STEPS” below.
Notice: The gender of the 2 pin plug may be reversed on newer models in order to prevent the improper connection to
the “Flash Enable” connector.