20
Auto CAN transmission:
( Automatic transmission cars ) :
Can Message 1 should look like this:
Change Byte 3 from “Engine Load” to “MAP Voltage”
AEM V2 is not capable of outputting the
MAP pressure on the CAN bus, so we will need to put in a scalar and offset in the gauge in order to
get our MAP Pressure.
CAN Message 1 should now look like this:
Notice that “MAP Volts” may change to one of the ADCR channels once you have made your
selection. This behavior is normal:
Summary of Contents for 4.3 TFT
