26
ECU Master Classic Termination:
The ECU Master Classic ECU does require that you have the CAN Expansion module in order to have
access to the CAN bus communication feature.
Connect Pin 1 on the Module to the GREEN wire on the harness.
Connect Pin 5 on the Module to the WHITE wire on the harness
The red wire on the BTI gauge harness should be tied to ig12 Volts while the black wire should be
tied to ground.
ECU Master Black Termination
Wire the White wire (CAN high) to
pin 12
on the 39 pin connector.
Wire the Green wire ( CAN low) to
pin 25
on the 39 pin connector. The Black wire will need to be tied to chassis
ground and the Red wire will need to be tied to an ignition source that has power only when the ignition is energized.
ECU Master Black Software Configuration
Summary of Contents for 4.3 TFT
