©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
23
SRE-2700 06-11-2004
INSTALLATION
INSTALLATION
CONNECTING THE POWER SOURCE
1) Check that:
• the circuit breaker is OFF.
• all foot clamps are in the correct position;
• the rail is straight (use a plumb line as a guide).
2) Determine the location of the wall outlet for the power supply.
3) Position the power supply in a suitable permanent location
near either the top or bottom end of the rail, depending on the
location of the wall outlet.
4) Place the pigtail harness end of the power cable near the
power supply.
5) Route the power cable to the end of the rail opposite the
power supply by threading it under the rail and behind the
foot clamps.
6) Notice that the end of the cable OPPOSITE THE PIGTAIL
HARNESS has been split slightly, and includes one male
and one female connector. The sheathing of one lead is ribbed
(in photo to left, finger points to ribbed sheath). The other
lead's sheathing is smooth.
7) Now that the power cable has been routed to the end of the
rail opposite the power supply (Step 5), take that length PLUS
approx. 8". Then:
• increase the split
• cut off the excess lead
• remove and discard the existing connectors
• strip the freshly cut wire ends.
• install the new connectors (provided)
8) Connect the power source leads to the bumper charge contact
leads as shown.
9) Secure the power lead to the rear clamps (ones closest to the
wall) using the wire ties provided.
Be sure that this wiring is mounted securely
to avoid damage.
circuit breaker
ribbed to red
(+) (female)
smooth to black
(-) (male
)
