©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2700 06-11-2004
14
INSTALLATION
RAIL JOINT ASSEMBLY
1) Assemble the rail joint by attaching the bottom plate to
the rail with the screws, lock washers and hex nuts
provided with the unit. Install the bolts, internal-tooth
washers and hex nuts through the joint blocks on both
sides of the rail. Tighten all bolts securely and make sure
screw heads are flush with the surface of the inside of the
rail.
PLEASE REFER TO EXPLODED VIEWS AT
BACK OF MANUAL.
NOTE:
The chamfered
edges of the
holes must face
"up" toward
the bottom of
the rail.
NOTE:
The rail is always installed
with the gear rack towards the
center of the stairs and gear
teeth facing the wall.
INSTALLATION
SUGGESTION
Once two sections of rail
are installed, and before
installing the carriage, run a
plomb line along the rail. If
the rail bows, insert shims
or readjust clamps.
