©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2700 06-11-2004
22
INSTALLATION
INSTALLATION
7) Connect the rocker switch lead first.
8) Pick up the swivel cover.
9) Plug in the seat safety switch.
10) Insert (1) wire tie through the hole in the swivel
stop as shown.
11) Tighten this wire tie around the wire harness (see
illustration to left).
12) Insert a second wire tie through the anchor as shown.
13) Tighten this second wire tie around the wire harness.
14) Trim the wire ties.
15) Tuck the wires to route them away from the spring and
seat safety switch to avoid pinching.
16) Make sure the spring sits in the opening of the swivel
switch actuator.
17) Remount the swivel cover.
18) Using a Phillips head screwdriver, insert and tighten
the (2) cylinder bumpers and (4) screws securing the
swivel cover.
INSTALLING THE SEAT ASSEMBLY (con't.)
INSTALLING THE FINAL LIMIT RAMP AND SWITCH
1) Make sure the carriage is positioned against the upper
bumper.
2) Position the final limit ramp so that the down side of the
ramp just touches the roller of the final limit switch.
3) Using a 10 mm wrench, tighten the (2) M6 screws as
shown in the photo to the left.
carriage against upper bumper
ramp just touches the roller
M6 screws
