BRP Ski-doo Tundra Series, Operator'S Manual

Page: 60 / 171

CONTROLS, INSTRUMENTS AND EQUIPMENT
mmo2008-003-074_a
HITCH NOT IN USE
1. Hitch
2. Support
3. Hairpin
21) Spare Drive Belt
A spare drive belt (not provided with
the vehicle) can be stored in the LH
side of engine compartment.
Install belt in the holder as shown.
mmo2010-007-022_a
LH SIDE - BELOW AIR FILTER
1. Spare drive belt
2. Holder
NOTICE
Install spare drive belt se-
curely. Avoid contact with moving
or hot parts.
22) Drive Belt Guard
Drive Belt Guard Removal
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed.
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
1. Remove the tether cord cap and
key.
2. Remove hood and LH side panel,
see procedure in this subsection.
3. Remove tool kit.
4. Remove retaining pin.
mmo2008-003-063_a
1. Retaining pin
5. Lift rear portion of guard then re-
lease from front tabs by pivoting the
guard outwards.
Drive Belt Guard Installation
When reinstalling drive belt guard,
position its cutaway toward front of
snowmobile.
1. Place the front LH slot of the guard
over the longest tab.
2. Pivot the guard inward to engage
the shortest tab in the RH slot.
58
______________