BRP Ski-doo Tundra Series, Operator'S Manual

Page: 113 / 171

MAINTENANCE PROCEDURES
mmo2007-009-022_a
1. Rubber boots
4. Press and pull both sides of the re-
taining clip at the same time to re-
lease it from bulb support.
mmo2007-009-063_a
Step 1: Push both sides
Step 2: Pull to release
1. Retaining clip
5. Pull bulb and replace. Properly rein-
stall parts.
mmo2007-009-064_a
PULL BULB AND REPLACE
Headlights Beam Aiming
Remove gauge, refer to HEADLIGHTS
BULB REPLACEMENT
. Turn knob to
adjust beam height.
mmo2007-009-023_a
TYPICAL
1. Knobs
Taillight Bulb Replacement
All Models Except Tundra Extreme
1. Remove taillight housing by care-
fully pulling on lens at both ends
using an equal force.
mmr2008-039-012_a
TYPICAL - CAREFULLY PULL OUT AT
CORNERS
NOTICE
Taillight housing is held in
place by two plastic pins inserted in
rubber grommets. If taillight hous-
ing is not removed perpendicularly
to the taillight holder, mounting pins
may break and housing will have
to be replaced. Do not pull taillight
housing out too far to avoid damag-
ing wiring.
______________
111