BRP Lynx Commander 800R E-TEC 2018, Operator'S Manual

Page: 86 / 118

MAINTENANCE PROCEDURES
NOTICE
Vehicle must be on a level
surface.
Oil level must reach the threaded
hole's lower edge.
NOTE: Oil level is allowed to be 2 mm
below the lower surface of the check
hole.
mmo2009-004-033_a
1. Check plug
To add oil, proceed as follows:
1. Remove the filler cap.
mmo2009-004-034_a
TYPICAL
1. Filler cap
2. Pour recommended oil in gearbox
by the filler hole.
Oil level is correct when it just begins
to come out of the check plug orifice.
3. Reinstall the oil level check plug and
tighten to specification.
TIGHTENING TORQUE
Gearbox oil
level check
plug
10 N•m ± 1 N•m
(89 lbf• in ± 9 lbf• in )
Drive Belt
Drive Belt Inspection
Inspect belt for cracks, fraying or ab-
normal wear (uneven wear, wear on
one side, missing cogs, cracked fab-
ric). If abnormal wear is noted, prob-
able cause could be pulley misalign-
ment, excessive RPM with frozen
track, fast starts without warm-up pe-
riod, burred or rusty sheave, oil on belt
or distorted spare belt. Contact an au-
thorized Lynx dealer.
Drive Belt Replacement
Drive Belt Removal
1. Remove tether cord cap from en-
gine cut-off switch.
2. Remove the drive belt guard, re-
fer to CONTROLS, INSTRUMENTS
AND STANDARD EQUIPMENT
.
3. Insert the driven pulley expander
provided in the tool kit in the
threaded hole on the adjuster hub
as shown.
mmo2012-005-980
PULLEY EXPANDER ON ALUMINUM
ADJUSTER HUB
_______________
83