BRP Lynx Commander 800R E-TEC 2018, Operator'S Manual

Page: 36 / 118

CONTROLS, INSTRUMENTS AND STANDARD EQUIPMENT
Refer to
GEARBOX OPERATION
in
OPERATING INSTRUCTIONS
for de-
tails.
NOTE: It is necessary to push shift
lever knob down to move it from neu-
tral to reverse gear.
NOTE: Do not shift when vehicle is
moving.
9) Tool Kit
A tool kit containing tools for basic
maintenance is supplied with the vehi-
cle.
The tool kit support is attached to the
drive belt guard.
NOTICE
Make sure tool kit is prop-
erly secured to avoid contact with
belt or pulley.
To remove the tool kit support from
the pulley guard, unlock the tab from
underneath the pulley guard and pull
the tool kit support towards front to
release it.
619900929-002_a
1. Tool kit
2. Drive belt guard
10) Front and Rear
Bumpers
To be used whenever snowmobile re-
quires manual lifting.
CAUTION Use proper lifting
techniques, notably using your legs
force. Do not attempt to lift either
end of the vehicle if it is above your
limits. Use appropriate lifting de-
vice or have assistance to share lift-
ing stress if possible.
619900929-003_a
1. Front bumper
fmo2012-003-007_a
TYPICAL
1. Rear bumper
NOTICE
Do not use skis or ski han-
dles to pull or lift snowmobile.
_______________
33