BRP Lynx Commander 800R E-TEC 2018, Operator'S Manual

Page: 116 / 118

MONITORING SYSTEM
PILOT
LAMP(S)
ON
BEEPER
MESSAGE
DISPLAY
DESCRIPTION
—
Short
beeps
repeating
rapidly
SHUTDOWN
Shutdown procedure in force due to engine
overheating or fuel pump problem, remove
tether cord cap from engine cut-off switch
and contact an authorized Lynx dealer.
— —
COMMUNICATION
Communication problem between ECM
and gauge. Stop engine, remove tether
cord cap . Wait a few minutes, then start
engine. If problem persists, contact an
authorized Lynx dealer.
2 short
beeps
—
Good key, vehicle ready to operate.
2 short
beeps,
repeating
slowly
CHECK KEY
Unable to read key (bad connection). Make
sure the key is clean and correctly snapped
on post.
D.E.S.S.
Short
beeps
repeating
rapidly
BAD KEY
Invalid key or key not programmed. Use
the proper key for the vehicle or have the
programmed.
— —
(blinking)
Fuel level sensor problem.
— —
THROTTLE OPEN
Throttle lever applied while attempting an
engine start (engine cranks but won't run).
Release throttle while starting.
— —
DROWN MODE
Throttle lever wide open while attempting
an engine start (engine cranks but won't
run). Release throttle while starting.
______________
113