CONTROLS, INSTRUMENTS AND STANDARD EQUIPMENT
4) Pilot Lamps and Messages
mmo2008-003-024_a
TYPICAL — PILOT LAMPS
See table below for usual pilot lamps information. Refer to
MONITORING SYS-
TEM
for details on malfunction pilot lamps.
PILOT
LAMP(S)
ON
BEEPER
MESSAGE DISPLAY
DESCRIPTION
4 short
beeps
every
5 minutes
LOW OIL
Injection oil level is low. Stop vehicle in a safe place then,
replenish injection oil reservoir.
—
—
Low fuel level. One (1) bar left in fuel level display.
Replenish fuel tank as soon as possible.
Long
beeps
repeating
slowly
REVERSE
Reverse is selected.
—
—
High beam headlights are selected.
—
—
WARM UP
Engine and/or injection oil need to warm-up before normal
operation. The engine's RPM is limited until desired
temperature is reached (up to 10 minutes when driving).
Warm-up period may occur after a restart in very cold
weather.
5) MODE (M) Button
Button use to navigate in gauge multifunction display.
NOTE:
MODE (M) button on the multi- switch housing has the same functions and
can also be used.
6) SET (S) Button
Button used to navigate, adjust or reset gauge multifunction display.
In order to memorize settings, engine must be running.
NOTE:
SET (S) button on the multifunction switch has the same functions and can
also be used.
_______________
35
Summary of Contents for Lynx Commander 800R E-TEC 2018
