BRP Can-Am Commander XT 1000R 2021, Operator'S Manual

Page: 100 / 236

CONTROLS
219001731-001_c
TYPICAL
1. Override/DPS button
2. Engine start button
Override Function
The override switch main function is to
bypass the engine speed limiter in re-
verse operation by allowing maximum
engine torque.
WARNING
Use the "override" mode only if the
vehicle is caught in mud or other
soft terrain and the "low range" is
not enough. Make sure the area is
secure before using the "override"
mode. Do not use the "override"
mode when driving normally in
reverse, this would result in exces-
sive speed.
To engage the override function, pro-
ceed as follows:
While the shift lever is set to REVERSE
position.
1. Ensure that the vehicle is stopped.
2. Press and hold the override button
then press the throttle lever gradu-
ally.
NOTE: When using the override func-
tion, the gauge will scroll an OVER-
RIDE message to confirm that the
function is activated.
3. To disengage the override function,
simply release the override button.
DPS Function (Models with DPS)
This button is also used to change the
DPS (Dynamic Power Steering) mode.
For complete information on DPS
modes, refer to
TUNE YOUR RIDE
.
9) 2WD/4WD and Driving
Modes (if equipped)
Selector Switch
The 2WD/4WD and Driving Modes se-
lector is located on the RH side of the
handlebar.
This switch is used to select the 2WD
or 4WD modes.
219001961-004_a
4WD MODE - TYPICAL
TYPICAL
1. 2WD/4WD Selector
2. 2WD position
3. 4WD position
4. Driving modes selector
Bring the vehicle to a complete stop
with the engine idling before changing
between 2WD and 4WD modes or the
opposite.
NOTICE
Mechanical damage
may occur if the 2WD/4WD selec-
tor switch is used while vehicle is
moving.
To engage the 4WD mode, press the
switch down.
98
______________