The BeerGun has been shipped pre-assembled so you can visualize how it goes together. But it does
need to be cleaned and sanitized prior to the first use. The assembly steps follow, but disassembly is
simply the reverse of these steps.
Caution :
Do not disassemble until you have read the assembly procedure !
The filler may be permanently
damaged if not disassembled correctly.
Do not use excessive force on any of the parts during assembly or disassembly or they may be
permanently damaged. The sheet metal valve clip and the beer trigger are made of heat-treated
stainless steel, but can still be deformed and the tube grooves can be permanently damaged or bent. It
is also not necessary to firmly tighten the flare nut onto the elbow – a snug fit is all that is needed.
Do
NOT
use any cleaner or sanitizer containing
chlorine
such as bleach. Over time, this will pit and
erode stainless steel. It will also damage the brass parts of the filler. Any other non-chlorine sanitizer is
acceptable to use. Iodophor or StarSan both work very well and do not require rinsing. In any case, a
few minute soak is all that is recommended to prevent any damage to the brass fittings. Extended
soaking can lead to galvanic corrosion of the filler parts.
Prior to assembly, completely disassemble the filler and wash with a mild detergent. The included tube
brush makes it easy to clean the interior of the 2 tubes. Rinse all parts well and soak in your preferred
non-chlorine no-rinse sanitizer, including all the hoses and keg connectors.
Brouwland
Korspelsesteenweg 86 • B-3581 Beverlo - Belgium
Tel. +32-(0)11-40.14.08 • Fax. +32-(0)11-34.73.59
[email protected] • www.brouwland.com
Fig. 1
Fig. 2
2 / 8
Manual
058.121.4 Bottle-filler Beergun with accessory kit
058.122.3 Bottle-filler Beergun
