Brother SC-2000, Service Manual

Page: 67 / 150

III - 49
2.6 Reassembly of the Gears and Pulleys
(1) Set gear 21/47 on shaft A.
(2) After inserting shaft B through the clutch spring A, set gear 20/50.
(3) After inserting shaft C through the clutch spring A, set gear 68 and the
retaining ring.
(4) Set gear 21/47 and the retaining ring on shaft D.
(5) Set the clutch spring C on gear 25, and set gear 25 and then gear 50A on shaft
E.
Insert the hook of the clutch spring C into the groove of gear 50A, and set the
retaining ring.
(6) Set pulley 25 and gear 19/84 on shafts F and G respectively, and set the timing
belt (MXL belt B69) on pulley 25 and gear 19/84.
Set the flanges and the retaining rings on shafts F and G.
(7) Set pulley 18 on shaft H.
Set the timing belt (MXL belt 221) on shaft H and gear 44, and set gear 44 and
the retaining ring on shaft I.
Set the flange and the retaining ring on shaft H.
Note: Check that the end of the paper eject roller spring is fitted in the groove of the
bearing.
(8) Set gear 20/50, the flange, and then retaining ring on shaft J, as shown in Fig.
3.63