Brother SC-2000, Service Manual, Page: 60 / 150

III - 42
2.3 Reassembly of the Label Guide Assy
Set the retaining ring, the washer, and the clutch spring on the paper feed roller
shaft.
Note 1: Before setting the clutch spring, apply grease on the shaft.
Pass end A of the paper feed roller through the hole in the main chassis from the
inside, and then pass end B through the hole on the opposite side of the main
chassis.
Set the bearings and the retaining rings on both ends of the paper feed roller from
the outside of the main chassis. (Insert the hook of the clutch spring into the groove
of the bearing, as shown in Fig. 3.56.)
Retaining ring
Paper feed roller
Bearing
Clutch spring
Retaining ring
Bearing
Washer
Retaining ring
Main chassis
A
B
Clutch spring
Hook
Bearing
Groove
Paper feed roller
Fig. 3.56