Brother SC-2000, Service Manual, Page: 59 / 150

III - 41
Set torsion spring R on the projection of the main chassis so that hook A of torsion
spring R will be inserted into the hole in the main chassis.
In the same manner, set torsion spring L on the opposite side.
Pass each end of the nip roller through the hole from the inside of the main chassis,
and set the retaining rings on both ends of the nip roller from the outside of the
main chassis.
Set the film path in the main chassis, and secure it with the seven screws.
Note 3: Insert the hooks of the torsion springs into the grooves of the nip roller.
Note 4: Make sure that part D of the outer plate is inserted into hole E in the main
chassis, as shown in Fig. 3.55.
Screws
Torsion springs
Nip roller
Screws
Paper feed roller
Retaining
ring
Retaining ring
Film path
A
Retaining ring
Bearing
Retaining ring
Bearing
Main
chassis
Film path
Outer
plate
Main
chassis
E
D
Fig. 3.55