19
Note 1: Always make sure to adjust these values following the steps above. (continuous
→
62mm 2Lables
→
62mm 1Label)
Note 2: The “OK” button is disabled before these three types of adjustment are
completed.
(2) Set the free length roll of 102mm into the machine and click the “Print
test(continuous) (A)” button to implement the test print. (Refer to Print result (A).)
(3) Measure the top margin on the print result and make sure that it is 3mm±0.25mm.
If it is not in this range, select the appropriate “Adjusted value” and click the “Apply
(0)” button. Then, click the “Print test (continuous) (A)” button and print the print
pattern for inspection again. (Refer to Fig. 21.)
Check that the top margin of the print result is 3mm±0.25mm.
Fig. 21 “Adjustment print test” screen
3mm
±
0.25mm
Printing direction
If the margin is adjusted, select the appropriate
Adjusted value and click the “Apply (0)” button.
Print the print pattern
for inspection.
Print result (A)
