Brother Innov-is 2500D, Operation Manual

Page: 25 / 221

LOWER/UPPER THREADING
24
LOWER/UPPER THREADING
Winding the Bobbin
This section describes how to wind thread onto a
bobbin. With this machine, you can use the
supplemental spool pin to wind the bobbin while
sewing using the main spool pin.
■
Using the Supplemental Spool Pin
While sewing embroidery, the bobbin can
conveniently be wound.
a
Supplemental spool pin
a
Turn on the machine, and then open the top
cover.
b
Align the groove in the bobbin with the spring
on the bobbin winder shaft, and then set the
bobbin on the shaft.
a
Groove in bobbin
b
Spring on bobbin winder shaft
c
Set the supplemental spool pin in the “up”
position.
a
Supplemental spool pin
d
Place the spool of thread on the supplemental
spool pin so that the thread unwinds from the
front. Then, slide the spool cap as far as
possible onto the supplemental spool pin to
secure the thread spool.
a
Supplemental spool pin
b
Spool cap
c
Thread spool
CAUTION
• The included bobbin was designed specifically for
this sewing machine. If bobbins from other models
are used, the machine will not operate correctly.
Use only the included bobbin or bobbins of the same
type (part code: X52800-150).
Actual size
This model Other models
11.5 mm
(approx.
7/16 inch)
7, 8
2
9,10
1
o
l
5 6 3, 4
a
a
b
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool pin
and cause the needle to break.
• Use the spool cap (large, medium, or small) that is
closest in size to the thread spool. If a spool cap
smaller than the thread spool is used, the thread may
become caught in the slit on the end of the spool.
a
a
b
c