Brother BE-438HS, Service Manual

Page: 61 / 223

5. SETTING FUNCTION
KE-430HX/KE-430HS, BE-438HX/BE-438HS 50
4 Apply the changed parameter setting.
Touch the OK key (7).
・
The setting value (4) will stop blinking and illuminate,
and this means that the parameter setting is confirmed.
・
If you change the memory switch number or touch the
menu key or the back key (8) to
switch the screen without touching the OK key, you can
cancel the changes.
5 Repeat steps 2 to 4 above to set each memory switch.
6
Exit setting mode.
Touch the back key or the menu key .
・
The display will return to the setting menu screen.
<List of memory switches (for operators)>
In the memory switch setting mode which can be checked from the adjustment menu (refer to "4-2. Memory switch setting
method (for technicians)"), the memory switches with the bottom two digits from 50 to 99 will also be displayed.
No.
Setting
value
Setting detail Initial value
001
Work clamp / button clamp lift timing after sewing is completed
1
OFF Does not lift automatically.
1 Lifts at the final stitch position.
2 Lifts after moving to the home position.
100
Sewing speed at the sewing start
ON
OFF
The sewing speed for the first 1 to 5 stitches is set by memory switch Nos. 151 to
155.
(Refer to "4-3. List of memory switches (for technicians)" for details on memory
switch Nos. 151 to 155.)
ON
Slow start patterns can be selected from the slow start settings in the setting menu
screen.
200
Single-stitch test feed
430H: OFF
OFF
When the foot switch is depressed to the 2nd step (start switch), test feed moves
automatically to the final stitch, and when the foot switch is depressed to the 1st step
(work clamp switch), quick feeding is carried out.
438H: ON
ON
The test feed moves 1 stitch at a time when the foot switch is depressed to the 1st
step (work clamp switch).
In addition, test feed advances one stitch at a time when the machine pulley is
turned by hand.
300
Production counter display
OFF
OFF The production counter is displayed when using cycle programs.
ON The garment counter is displayed when using cycle programs.
402
X scale/Y scale unit (mm/%) (* The mm display may differ slightly from the actual sewing size.)
OFF
OFF Displayed as %.
ON Displayed as mm.
406
Switching program numbers by F keys
OFF
OFF The program number switching function is disabled.
ON
When the F1 to F4 keys are pressed, operation switches to the program number
which has been pre-assigned to the respective key.
Assignment to F1 key: memory switch No. 407
Assignment to F2 key: memory switch No. 408
Assignment to F3 key: memory switch No. 409
Assignment to F4 key: memory switch No. 410
(4)
(7)
(8)