Brother BE-438HS, Service Manual

Page: 58 / 223

5. SETTING FUNCTION
47 KE-430HX/KE-430HS, BE-438HX/BE-438HS
5-2. X and Y parallel movement of sewing patterns
The work clamp/button clamp can be moved to any desired position so that sewing patterns which have already been
programmed can be moved in parallel directions forward, back or to the left or right.
Use this when you would like to correct the sewing position with respect to the work clamp/button clamp.
1
Touch the program number change key or a
program number to switch to the program change screen,
and then select the program number in that screen.
*
If a cycle program is selected, the following operation
cannot be carried out. Select a sewing program other
than a cycle program.
2 The display will switch to the parallel movement setting screen.
1
．
Press the menu key to switch from the home screen to the setting menu.
2 ． Touch "Parallel movement setting" in the menu to switch to the parallel movement setting screen.
・ The amount of parallel movement in which has currently been set the X and Y directions will be displayed in the
parallel movement setting screen in mm units.
3 Depress the foot switch to the 2nd step.
・
Home position detection will be carried out.
・
The settings can be changed.
4 Switch to X or Y direction. You can touch the feed amount setting value for the
direction you would like to set to switch to the respective
setting.
*
You can switch between the "X feed" (1) and "Y feed"
(2) setting values as often as desired.
5
Set the feed in the X direction
Each time the or key is pressed, the work
clamp/button clamp will move by 0.05 mm.
* In X-scale parallel movement mode, the work
clamp/button clamp will move to the left when the
key is pressed, and to the right when the
key is pressed.
* If the sewing pattern goes outside the sewing area as
a result of parallel movement, sewing will not be
possible.
For example, program number 1
For example, set to 3.00.
2nd step
(1)
(2)
4441Q