Brother BAS-761, Instruction Manual

Page: 88 / 155

Programmer
87
Chaprter 3 Programming with Command Function
2. Move the needle with . Press
L
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Input the stitch length, then press
M
.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Move the needle with . Press
L
when the needle point is at point B of the
pattern.
5. Repeat step 4 and create the program to
point D.
6. Move the needle with . Press
L 7 8 9
when the needle point is at point
E of the pattern.
Point E becomes a sharp corner.
7. Press
M
.
To change the stitch length, specify the pitch value before
pressing
M
.
8. Repeat step 4 and create the program from
points F to H.
9. Press
L 7 8 9
as in step 6 at point I.
The range from points C to E is programmed.
2
Inputting the end code
1. Press
E 1 1 1
.
The needle returns to the sewing start position.
3
Saving
1. Specify the program number on the
operation panel, then press switch for
writing into the floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.