Brother BAS-761, Instruction Manual

Page: 143 / 155

142
Chapter 5 Practical programming examples
Programmer
Operating procedure
1
Programming
1. Press
P
.
The work clamp comes down and the programmer screen is displayed.
2. Move the needle with . Press
L
when
the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
3. Input the stitch length.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Press
LI LI
.
5. Move the needle with . Press
L
when
the needle point is at point B of the pattern.
6. Repeat steps 4 and 5 and create the program to
point E.
7. Input the number of stitches to return the needle
to the position where two row switch is input,
then press .
5 is input in the example. The needle moves 5 stitches back.
8. Press
0 1 8
, then press
L
.
The screen to set the attributes appear and two row switch is set.
9. Input the number of stitches to proceed the
needle to point E, then press .
5 is input in the example. The needle moves 5 stitches ahead.
10. Press
9
, then press
LI LI
.
9
is a command for needle tacking. Input the stitch length
in . 0.5 mm is input in the example.