Bromic Heating 2620970, Installation, Instruction And Service Manual

Page: 25 / 32

Flued Indoor Gas Heater - Instruction Manual
25
July 2019 - V1
26 CUSTOMER SERVICE
Cleaning Electrode
The ignition electrode (1) and revelation (2) have to
be cleaned very carefully, after a period of time they
get fragile because of the work they have to perform.
- Unscrew the screws (3 o 4) and extract the electro-
de group (1 o 2) using a little brush with metallic hair
for cleaning, after insert the electrode group (1 o 2) if
necessary exchange the seal gasket (5) be real
careful to not damage the electrode.
Pressure switch tubes
Check if there are deposits or condensation within
the pipes pressure measurement:
- Fan combustion air pressure switch.
- Exhaust fumes / pressure.
Blow, disconnect the switch and test it, otherwise,
may be damaged.
Preliminary operations:
-Disconnect the electrical alimentation taking off
the electrical plug; place the wall switch to the
“off” position.
-Close the gas tap.
-Wait that the appliance gets cold completely.
Replacing the Control board with Flame Control
To remove and refit the Flame Control board (1), fol-
low the instructions below:
- loosen the retention screw (2) of the board cover;
- remove the connectors from their plugs;
- completely replace the electronic board, taking care
to reconnect all the wires properly.
COMPONENTS REPLACEMENT






