Bromic Heating 2620970, Installation, Instruction And Service Manual

Page: 24 / 32

Flued Indoor Gas Heater - Instruction Manual
24
July 2019 - V1
Whenever the apparatus is going to be regulated at
pure Propane, to avoid heat exchanger overheating,
is necessary knowing that you are using the proper
gas, but if you use a un proper gas like a mixture of
Propane/Butane or pure Butane you might have pro-
blems.
Regulation min pressure
Proceed to the minimum pressure regulation after
that you regulated the max pressure!
To make a regulation operate on the screw that is on
the modulator body (4).
Rotating the regulator screw (3) clockwise the pres-
sure decrease, rotating counter clockwise the pres-
sure increases.
The appliance maintenance is important for the effi-
ciency and the reliability of the radiator. We recom-
mend that Technical Service Assistance perform the
maintenance once a year.
Preliminary operations:
-Disconnect the electrical alimentation; place the wall
switch to the “off” position.
-Close the gas tap.
-Wait that the appliance gets cold completely.
Cover clean
The only cleaning that is required by the owner,
involves removing the cover, and wiping it clean the
dust, which may have collected.
Do not put grease or lubricants on any parts of the
appliance.
To clean plastic or painted parts don’t use any pro-
duct that will cause damage to the apparatus.
It is important that the switch is turned to the “off” posi-
tion on the control penal. Position the wall switch on off.
Wait that the appliance gets cold completely
Do not allow water or any other liquid to be applied
directly to the cover, uses dampened clothes to do
the operation that you want.
Internal clean
For the correct disassembly and assembly see in the
relative section.
Burner clean out
If you want a good burner clean, especially if the
appliance has been working in dirty.
Places, or it didn’t work at all, use the compressor to
blow next to the injector; it will come out all the resi-
dues and the impurity caused from the burner.
Check all the injectors if are good.
Don’t use metallic utensil.
ORDINARY MAINTENANCE
APPLIANCE CLEAN OUT
25
CUSTOMER SERVICE