Bromic Heating 2620970, Installation, Instruction And Service Manual

Page: 26 / 32

Flued Indoor Gas Heater - Instruction Manual
26
Replacing the room probe
Follow the instructions below to remove and refit the
probe:
- disconnect the connector of the probe cable (1)
from the control unit (2);
- take out the damaged probe;
- replace the component part and fit it back, perfor-
ming removal operations in the opposite sequence.
Replacing a convenction fan
Follow the indication to replace the fan
- Take off the electrical connectors (1) that are on the
fan motor.
- Take off the ground connector that is on the fan
motor.
- Unscrew the 4 screws (2) that fasten the fan to the
supports (3)
- Replace the fan then after do the assemblage
Replacing a burnt out protection fuse
In the event of the appliance not switching back on
after a short circuit, immediately check the condition
of the protection fuse and proceed as follows:
- remove the fuse (1) and check its condition. If it has
gone brown or the inside filament is broken, it will
have to be replaced with another of the rapid type:
F1AT- 250 V.
Comburant air fan replacement.
Follow the indication to replace the comb rent air fan.
- Take off the electrical connectors from the motor.
- Take off the electrical ground connectors from the motor.
- Remove the tube (1) from the pressure tap.
- Disassemble the clamp (2) unscrewing the screws (3)
divide the clamp with the sleeve in two parts (4) fasten the
fan metering screw (5) to the combustion chamber (6).
- Disassemble a half sleeve (4) with the clamp (2) and
after the fan (5).
- Unscrew the screw away the fan frame complete of
curves connector (7) and ant vibration gasket (8).
- Disassemble the curves connector (7) from the mete-
ring screw of the broken fan and reassemble (complete
of ant vibration gasket (8) on the new component.
- Reassemble the fan in the reverse way being careful
of inserting before the curves connector complete of O
Ring (9) in the intake tube.
- Lock the clamp well, (2) until the sleeve (4) in rubber
can seal the collegaments of the fan, then fastens well
the fan frame with the screw represtinig the electrical
connector and reconnecting the pressure tap.










 



27 CUSTOMER SERVICE