Brocade Communications Systems VDX 8770-4, Hardware Installation Manual, Page: 65 / 141

1. Unpack the rack kit hardware.
2. Loosen the two 10-32 adjusting screws securing the each sliding bracket to the saddle (see Figure 34 on page 62) and slide
the brackets as far backward as possible.
3. Install the saddle to the rack posts using the following steps while referring to the following figure. Also refer to Figure 38 for
details on securing screws to the rack.
a)
Install the saddle with the angled portion facing the port side of the rack posts using four 10-32 screws with square-cone
washers on each sliding bracket. Tighten the screws to 32 in-lb (36.86 cm-kg).
b) Tighten the two 10-32 adjusting screws on each side of the saddle.
FIGURE 37 Saddle installed in equipment rack.
1. Saddle
2. 10-32 screws with square-cone washers
3. Adjusting screws (two on each side of the saddle)
Mounting the Device
Brocade VDX 8770-4 Hardware Installation Guide
53-1002563-10 65