Brocade Communications Systems VDX 8770-4, Hardware Installation Manual, Page: 104 / 141

4. If you are replacing the line card with a line card of a different type, follow these steps:
a) Enter the configure terminal command to enter global configuration mode
b) Enter the rbridge-id
rbridge-id
command to enter RBridge ID configuration mode.
c) Enter the no linecard
slot_number
command. This command removes the line card configuration and its associated
interface configuration from the chassis database so a different type of line card can be used in the slot.
5. Disconnect all cables and transceivers from the line card.
6. Unscrew the two captive screws at the ends of the line card using the Phillips screwdriver.
7.
Open the ejectors by rotating them toward the center of the line card face. Pull the line card out of the chassis using the
ejectors.
FIGURE 54 Removal and replacement of the line card
8. If you are replacing the line card with a line card of a different type, follow these steps before replacing the line card.
a) Enter the linecard slot_number command followed by a question mark (?) to display the line card types.
b) Enter the linecard slot_number linecard_type command using the proper line card type.
c) Enter the exit command twice to return to privileged EXEC mode.
Replacing a line card
Review the ESD precautions on page 101 before replacing a line card.
Complete this procedure to insert a new line card. Refer to the illustration provided with the procedure.
1. If you are replacing the line card with a line card of a different type, follow these steps:
Removal and Replacement Procedures
Brocade VDX 8770-4 Hardware Installation Guide
104 53-1002563-10