Brocade Communications Systems VDX 8770-4, Hardware Installation Manual, Page: 59 / 141

Installing the air filter
1. If desired, install the air filter to the air intake grill using the five captive screws, as shown in the following figure.
FIGURE 32 Installing the air filter
2. Complete the following steps to mount the new front air filter on the air intake.
a) Orient the new filter over the five mounting holes using the screws as guides.
The mounting is asymmetric, so the holes match up only one way.
Be sure the side marked BOTTOM is on the bottom.
b) Using the #2 Phillips screwdriver, initiate the threads, two turns per screw, until all five are started.
c)
Tighten all five screws, one at a time.
Do not overtighten the screws as this will compromise the frame, admitting unfiltered air.
The following figure shows the device with the air filter installed.
Mounting the Device
Brocade VDX 8770-4 Hardware Installation Guide
53-1002563-10 59